Page 1 of 1

RC-1 issue?

PostPosted: Thu Nov 29, 2018 4:28 pm
by bill0287
Something is going on with my loop pedal. There used to be three lights on when the pedal was stopped (I think it was stopped), but now the LED display is blank. Also, when I stop a loop session, I am unable to start it again by pressing the button. What have I done to mess this up?

Update: I think the three leds only show when there is a loop in memory and not when it has been erased - is this correct?

Re: RC-1 issue?

PostPosted: Fri Nov 30, 2018 4:21 pm
by BearBoy
Hi Bill0287.

Everyone's decamped over to http://www.bossareaforum.com so it might be worth asking your question there.